ARCHIVE: Australian Ham Radio Discussion Forum ( AHRDF )

Full Version: FT991 drift on digital modes
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Here is an interesting one for you.

I have an FT991 radio which I've been using a lot on WSPR - mainly 6 metres. I have noticed through testing that it seems to drift. I have had several spots from stations that indicate up to 4Hz drift. Usually it's about 2-3 maximum.

With that in mind, you'd think that 2m and 70cm would be bad. Not so. I did testing on the bench and confirmed that drift at 70cm seems to be 2-3Hz too, at worst when compared with another GPS locked radio.

I located the 30.225MHz reference in the radio, it sits underneath a plug in PLL board, on the main board. I placed a small piece of styrofoam over the TCXO in case it was getting some air flow over it. This seemed to make things more stable at 70cm, yet I still have the drift at 6 metres. I can't imagine it using a different reference. Perhaps the 6 metre PA is located directly underneath?

Anyone got any other ideas. Wish these rigs came with GPS locking as standard..