+- ARCHIVE: Australian Ham Radio Discussion Forum ( AHRDF ) (https://www.ahrdf.net/forum)
+-- Forum: GENERAL (https://www.ahrdf.net/forum/forum-29.html)
+--- Forum: Transceivers, Transmitters & Receivers (https://www.ahrdf.net/forum/forum-18.html)
+--- Thread: Icom IC-7300 SETUP for WSJT/FT8 Digital Modes (Easy and Simple) (/thread-1047.html)
Icom IC-7300 SETUP for WSJT/FT8 Digital Modes (Easy and Simple) - VK7HH - 06-06-2021
Got a Icom IC-7300 you want to use on digital? I will show you exactly how to setup your Icom IC-7300 for use with WSJT-X and other digital modes such as FT8.
These are my settings on my radio that work perfectly for WSJT-X.
[Video: https://www.youtube.com/watch?v=mxJlrZRCf_I]
**See below details on CI-V control and Split**
The baudrate you use in WSJT-X is dependant on if CI-V USB Port is set to Unlink from [Remote] or Link to [Remote].
Link to [Remote] = Use the CI-V Baud Rate on Page 1 of the CI-V menu
Unlink from [Remote = Use the CI-V USB Baud Rate on Page 2 of the CI-V Menu
**When setting Split in WSJT-X**
"Either method (Rig or Fake it) will result in a cleaner transmitted signal, by keeping the Tx audio always in the range 1500 to 2000 Hz so that audio harmonics cannot pass through the Tx sideband filter"
RE: Icom IC-7300 SETUP for WSJT/FT8 Digital Modes (Easy and Simple) - VK3RX - 07-06-2021
Thanks again Hayden
Great info and video as usual.
RE: Icom IC-7300 SETUP for WSJT/FT8 Digital Modes (Easy and Simple) - VK7HH - 13-06-2021
(07-06-2021, 01:38 PM)VK3RX Wrote: Thanks again Hayden
Great info and video as usual.
Thank you Damien,
Appreciate you watching
