+- ARCHIVE: Australian Ham Radio Discussion Forum ( AHRDF ) (https://www.ahrdf.net/forum)
+-- Forum: BAND BY BAND (https://www.ahrdf.net/forum/forum-28.html)
+--- Forum: 1296MHz, Microwave & Opto (https://www.ahrdf.net/forum/forum-7.html)
+--- Thread: Freescale 1296 amp design (/thread-11.html)
Freescale 1296 amp design - VK4UH - 10-09-2016
Does anyone know if anyone is producing a board,kit or even complete pallet for the Freescale 1296 SSPA AS DESCRIBED IN DUbus Vol44 4.quarter?
Kevin VK4UH
BRisbane
Re: Freescale 1296 amp design - VK4REX - 11-09-2016
Hi Kevin
There was the possibility of getting a pcb from the Freescale club but that all seems to have died since Freescale was taken over by NXP.
The main problem is getting a pcb made on the substrate they used - especially in small quantity. All the other bits are available and I managed to get a sample of the fet but it stopped there for me.
Rex
Re: Freescale 1296 amp design - VK3PP - 23-09-2016
Hi KJ and Rex
There is a bit of a discussion about these said amps here http://www.ozlogger.net/forum/viewtopic.php?f=24&t=36
Matt
RE: Freescale 1296 amp design - ZL3RC - 03-01-2018
(10-09-2016, 06:01 PM)VK4UH Wrote: Does anyone know if anyone is producing a board,kit or even complete pallet for the Freescale 1296 SSPA AS DESCRIBED IN DUbus Vol44 4.quarter?
Kevin VK4UH
BRisbane
Just posted a new thread re Jim (W6PQL) new 23cm amp. Looks like this one well be available not like the Freescale Dubus amp.
I can't wait to get my hands on one
Roger ZL3RC