+- ARCHIVE: Australian Ham Radio Discussion Forum ( AHRDF ) (https://www.ahrdf.net/forum)
+-- Forum: GENERAL (https://www.ahrdf.net/forum/forum-29.html)
+--- Forum: Transceivers, Transmitters & Receivers (https://www.ahrdf.net/forum/forum-18.html)
+--- Thread: IC-9100 no TX audio fault & a fix (/thread-787.html)
IC-9100 no TX audio fault & a fix - VK3BA - 03-05-2019
G'day All,
I saw an interesting fault on my IC-9100 tonight. I've had this rig since about 2013 (inc 23cm & DStar options) and have regularly used it remotely from around VK3 via the BA1 remote client. One of the shack PC's is on 24/7 as is this rig for remote access. Been running fine for a few years.
Got home tonight, threw the Heil Proset headset on, hit the foot switch and no TX audio using the rig locally from the shack. Tried a desk mic, hand mic, etc... same result. Played around with the on-board mic audio gain settings... same result... using my IRLP node repeater in audio reflector mode. After a little bit of research, I performed a partial reset of the rig and now the TX audio is as good as gold. The rig now performs & functions as per normal.
I haven't seen that fault before, therefore I wonder if anyone else has? I suspect it was a once in a blue moon processor lockup...
Cheers,