ARCHIVE: Australian Ham Radio Discussion Forum ( AHRDF ) › GENERAL › Ancillary, Test Equipment, Components & Parts
NUC...Anyone using one?

Linear Mode
NUC...Anyone using one?
VK3LU Offline
Senior Member
****
Posts: 171
Threads: 41
Joined: Sep 2016
#9
08-08-2017, 05:09 PM
Hi Lou,
I had thought of that but I cannot find a driver in linux that allows wsjtx to CAT control an IC7300. It does not exist.
So I will stick with Windows.

Nev
Find
Reply


Messages In This Thread
NUC...Anyone using one? - by VK3LU - 06-08-2017, 06:47 PM
RE: NUC...Anyone using one? - by VK2ZIW - 07-08-2017, 07:42 AM
RE: NUC...Anyone using one? - by VK3ALB - 07-08-2017, 08:09 AM
RE: NUC...Anyone using one? - by VK2EHQ - 07-08-2017, 08:46 AM
RE: NUC...Anyone using one? - by VK3LU - 07-08-2017, 10:41 AM
RE: NUC...Anyone using one? - by VK3HZ - 07-08-2017, 10:49 AM
RE: NUC...Anyone using one? - by VK3LU - 07-08-2017, 11:03 AM
RE: NUC...Anyone using one? - by VK3ALB - 07-08-2017, 11:23 AM
RE: NUC...Anyone using one? - by VK3LU - 08-08-2017, 05:09 PM

Forum Jump: