18-08-2017, 03:55 PM
Rick,
I did not see your comment that you were going to run a 9100 and feed just 10watts (or 50 on 70 or 100 on 2 ) watts up the cable.
My comment regarding separate line switching related to where you are running an amplifier. For example in the setup I use for 1296, there is a 400w+ amplifier feeding RF up the cable, driven by a TS2000X.
At lower powers, DC switching is relatively safe, but if you are contemplating more power, then I would advise separate switching.
Cheers
Peter VK3QI
I did not see your comment that you were going to run a 9100 and feed just 10watts (or 50 on 70 or 100 on 2 ) watts up the cable.
My comment regarding separate line switching related to where you are running an amplifier. For example in the setup I use for 1296, there is a 400w+ amplifier feeding RF up the cable, driven by a TS2000X.
At lower powers, DC switching is relatively safe, but if you are contemplating more power, then I would advise separate switching.
Cheers
Peter VK3QI