20-02-2018, 04:12 PM
Pete
On this page : https://www.manualslib.com/manual/381816...l?page=112
Just above the rear panel diagram...
"Packet operation is easily accomplished on the FTDX5000 by connecting your TNC (Terminal Node Controller) to the transceiver, as in the illustration. "Packet" operation also applies to SSB-based AFSK data modes, such as PSK31, etc."
Note also details mentioning the FTDX5000 on http://www.tigertronics.com/sl_wirebm.htm ....
**On the FT-847, FT-920, FT-950, FT-1000MP, FT-DX1200, and FT-DX5000 you should also jumper Pin #5 to Ground.
I guess that it's the packet port that you will need to connect to..
On this page : https://www.manualslib.com/manual/381816...l?page=112
Just above the rear panel diagram...
"Packet operation is easily accomplished on the FTDX5000 by connecting your TNC (Terminal Node Controller) to the transceiver, as in the illustration. "Packet" operation also applies to SSB-based AFSK data modes, such as PSK31, etc."
Note also details mentioning the FTDX5000 on http://www.tigertronics.com/sl_wirebm.htm ....
**On the FT-847, FT-920, FT-950, FT-1000MP, FT-DX1200, and FT-DX5000 you should also jumper Pin #5 to Ground.
I guess that it's the packet port that you will need to connect to..
Doug VK4ADC @ QG62LG51
http://www.vk4adc.com
This Forum is only going to be as interesting as the posts it contains.
If you have a comment or question, post it as it may trigger or answer the query in someone else's mind.
http://www.vk4adc.com
This Forum is only going to be as interesting as the posts it contains.
If you have a comment or question, post it as it may trigger or answer the query in someone else's mind.