15-05-2018, 05:36 PM
Thanks Lou,
I'll have a look at them.
To round it off, the USB mixing desk took a little coaxing to get it talking to WSJT-X and then to work out fader, gain and EQ. For the record EQ I am using is 12kHz +15 (as far up as it will go) and 80Hz -15. The Rx VU level on the desk is around 0 to +6 dBu.
I fiddle with the mic gain, input fader to get the Rx working. I use the Main Mix Out fader to set the Tx signal below clip - again around +6 dBu. Of course it is in combination with the PWR control in the software.
I completed a couple of QSO's with some JA's but as my location and antennas leave a little to be desired, that is a good start.
Thanks for the help, it has been much appreciated.
I'll have a look at them.
To round it off, the USB mixing desk took a little coaxing to get it talking to WSJT-X and then to work out fader, gain and EQ. For the record EQ I am using is 12kHz +15 (as far up as it will go) and 80Hz -15. The Rx VU level on the desk is around 0 to +6 dBu.
I fiddle with the mic gain, input fader to get the Rx working. I use the Main Mix Out fader to set the Tx signal below clip - again around +6 dBu. Of course it is in combination with the PWR control in the software.
I completed a couple of QSO's with some JA's but as my location and antennas leave a little to be desired, that is a good start.
Thanks for the help, it has been much appreciated.