20-09-2018, 06:47 AM
It may not be spaced correctly for 450 ohm line but in the early days when everybody used open line feeders :
http://www.ssapl.com.au/product/44486-kn...uble-throw
Then again, you could disassemble the basic bits from this and reassemble on a different insulating material (eg kitchen chopping board) with the spacing set up differently to maintain the 450 ohm spacing.
http://www.ssapl.com.au/product/44486-kn...uble-throw
Then again, you could disassemble the basic bits from this and reassemble on a different insulating material (eg kitchen chopping board) with the spacing set up differently to maintain the 450 ohm spacing.
Doug VK4ADC @ QG62LG51
http://www.vk4adc.com
This Forum is only going to be as interesting as the posts it contains.
If you have a comment or question, post it as it may trigger or answer the query in someone else's mind.
http://www.vk4adc.com
This Forum is only going to be as interesting as the posts it contains.
If you have a comment or question, post it as it may trigger or answer the query in someone else's mind.