13-04-2020, 08:59 AM
My rotator project is finished... Next coronavirus-isolation project ??
The relay box component PCB was exposed, etched, drilled and built up on Saturday, put into a diecast box yesterday, then tested and mounted on the shack wall in place of a 4 position Daiwa coax switch. Late in the day I was switching between my main HF antennas as I moved band-to-band, rotating the HF yagis as desired, looking at the waterfall of FT8 signals. I made a few contacts on 10.1 MHz (30M), mainly into Europe and the USA so all is working well.
Here are a few images of the relay component..
The relay box component PCB was exposed, etched, drilled and built up on Saturday, put into a diecast box yesterday, then tested and mounted on the shack wall in place of a 4 position Daiwa coax switch. Late in the day I was switching between my main HF antennas as I moved band-to-band, rotating the HF yagis as desired, looking at the waterfall of FT8 signals. I made a few contacts on 10.1 MHz (30M), mainly into Europe and the USA so all is working well.
Here are a few images of the relay component..
Doug VK4ADC @ QG62LG51
http://www.vk4adc.com
This Forum is only going to be as interesting as the posts it contains.
If you have a comment or question, post it as it may trigger or answer the query in someone else's mind.
http://www.vk4adc.com
This Forum is only going to be as interesting as the posts it contains.
If you have a comment or question, post it as it may trigger or answer the query in someone else's mind.