21-12-2016, 01:42 PM
Hi All,
I've got an interesting fault with my DSE D-3800 P/S unit.
All works fine normally, no problem with regulation/current etc. However, sometimes the unit will be switched on and there is no output. Both the Warning (Overload) and ON LEDs are lit. There is no short circuit on the output.
Putting a heatgun on the side of the P/S for about 10-15 seconds causes the output to reappear again. I've opened the unit up, resoldered some suspect looking joints, tested with cold spray/heatgun to see if I can trace the location of the fault to no avail. It's most frustrating when your part way through transmitting and the output fails.
Anyone got an suggestions or come across this issue before?
Hayden
I've got an interesting fault with my DSE D-3800 P/S unit.
All works fine normally, no problem with regulation/current etc. However, sometimes the unit will be switched on and there is no output. Both the Warning (Overload) and ON LEDs are lit. There is no short circuit on the output.
Putting a heatgun on the side of the P/S for about 10-15 seconds causes the output to reappear again. I've opened the unit up, resoldered some suspect looking joints, tested with cold spray/heatgun to see if I can trace the location of the fault to no avail. It's most frustrating when your part way through transmitting and the output fails.
Anyone got an suggestions or come across this issue before?
Hayden