RG58 dipole connector.

[VK5WRJ]

Jon

You CAN use plumbing caps from Bunnings - the white PVC high pressure series - and a short length of the pipe they are designed to fit as a joiner.  eg  Holman 50mm Press PVC Cap End but use the smaller BNC connector series at/up to 100W  in lieu of SO239 sockets  /PL259 plugs (also known as UHF series).  eg Jaycar BNC PANEL Socket - SINGLE HOLE MOUNT PS0658, and use PP0650 clamp plug so you don't require a crimp tool.  Alternatively a box like a Jaycar HB6120 will do the job, and gives two options - either a toroidal core or just plain connecting wires inside.

Ideally you should use a 1:1 BALUN at the centre point so that there is less likelihood of radiation from the coax feeder - which does happen as a matter of course when a BALUN is not used.  These can be fitted into one of the sealed ABS boxes like the HB6120 (above) available from Jaycar or the heavier duty similar boxes available from electrical outlets.

Visit the web pages of VK6YSF for suggestions about BALUN and HF dipole projects :  https://vk6ysf.com/projects.htm

Doug VK4ADC

Thanks Doug,

Very helpful, the HB6120 box looks interesting will head down to Jaycar this morning and have a look.

Had a look at the HB6120 Doug, perhaps a bit tight for what I want, they had quite a range available, the HB6124 is quite a bit bigger, perhaps easier to work with, manipulate wires etc, so thats the one I bought, will let you know how I get on with it.
https://www.jaycar.com.au/sealed-abs-enc...m/p/HB6124