11-12-2022, 10:08 PM
In regard to the 50A Andersons;
I used to solder them. I had various levels of success. As a result I switched to hex crimping them.
Much better results straight away. Neater, less mess. I still use a bit of heatshrink over the end of the crimping and the start of the insulation.
Easier to have the cable pair turn a corner, no crystalisation. Good for field use.
Re the 30A Powerpoles:
I have just obtained a WARS kit, it includes a voltmeter. Looks to be the go for distribution to the 12v rigs etc. on the home desk.
I used to solder them. I had various levels of success. As a result I switched to hex crimping them.
Much better results straight away. Neater, less mess. I still use a bit of heatshrink over the end of the crimping and the start of the insulation.
Easier to have the cable pair turn a corner, no crystalisation. Good for field use.
Re the 30A Powerpoles:
I have just obtained a WARS kit, it includes a voltmeter. Looks to be the go for distribution to the 12v rigs etc. on the home desk.