Cable Penetrations - Corrugated Colorbond Walls
#4
Hello Colin,
if you opt for 75 or 90 mm storm water PVC, there is an abundance of fittings and angle you can use as building blocks.  I have three in the wall here and the outside uses a 45 deg downward bend the middle is a joiner that the outer fitting is connected too via a small bit of 90mm pipe, the inside uses a very neat wall transition I found at the Nuri Mitre 10 (thats why the middle section is a joiner as the transition needs that diameter to work, cannot find it on the Bunno's site for a sample but its worth a browse and let the imagination loose...  I stuff a square of foam mattress material in the hole once the cables are run, its easy to remove and stops the drafts Big Grin  the key is the imagination LOL
Peter Sumner, vk5pj

You have enemies? Good. That means you've stood up for something, sometime in your life.
- Winston Churchill
Reply


Messages In This Thread
RE: Cable Penetrations - Corrugated Colorbond Walls - by VK5PJ - 29-07-2024, 06:36 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)