06-06-2021, 11:07 AM
Got a Icom IC-7300 you want to use on digital? I will show you exactly how to setup your Icom IC-7300 for use with WSJT-X and other digital modes such as FT8.
These are my settings on my radio that work perfectly for WSJT-X.
[Video: https://www.youtube.com/watch?v=mxJlrZRCf_I]
**See below details on CI-V control and Split**
The baudrate you use in WSJT-X is dependant on if CI-V USB Port is set to Unlink from [Remote] or Link to [Remote].
Link to [Remote] = Use the CI-V Baud Rate on Page 1 of the CI-V menu
Unlink from [Remote = Use the CI-V USB Baud Rate on Page 2 of the CI-V Menu
**When setting Split in WSJT-X**
"Either method (Rig or Fake it) will result in a cleaner transmitted signal, by keeping the Tx audio always in the range 1500 to 2000 Hz so that audio harmonics cannot pass through the Tx sideband filter"
These are my settings on my radio that work perfectly for WSJT-X.
[Video: https://www.youtube.com/watch?v=mxJlrZRCf_I]
**See below details on CI-V control and Split**
The baudrate you use in WSJT-X is dependant on if CI-V USB Port is set to Unlink from [Remote] or Link to [Remote].
Link to [Remote] = Use the CI-V Baud Rate on Page 1 of the CI-V menu
Unlink from [Remote = Use the CI-V USB Baud Rate on Page 2 of the CI-V Menu
**When setting Split in WSJT-X**
"Either method (Rig or Fake it) will result in a cleaner transmitted signal, by keeping the Tx audio always in the range 1500 to 2000 Hz so that audio harmonics cannot pass through the Tx sideband filter"
